Your Go, from the first press.
One press switches skyBlip Go on. Two seconds switches it off. Between the two, the pad moves through pages and silences alarms.
In your hand
Find the pad, then the button.
The pad is touch-sensitive, on the top edge. On the left side, the button is the lower of the two controls. RESET is above it. The USB-C port is on the right. Two lights sit beside the screen: skyBlip's red, green or blue light and the charger's red light.
The e-paper screen keeps its image without power. The logo means the Go is off.
| Gesture | What it does |
|---|---|
| Tap the pad | Opens the next page. On a request, refuses it: the screen's CANCEL key. |
| Touch the pad, 1 s | Silences an active alarm. With no alarm, returns to the radar. |
| Press the button | From off, starts the radar. On a page, opens its menu. In a menu, changes the selected value. On a request, accepts it. |
| Hold the button, 2 s | Switches off. The logo stays on the screen. |
| The same hold, finger on the pad | Switches off with a blank screen, for storage. An image left all winter leaves a shadow. |
| Hold the button and plug the charger in | Starts and charges. Plugging in alone charges and leaves it off. |
| Press RESET | Restarts the Go. |
| Press RESET twice within half a second | Opens TECHOBOOT, a USB drive for installing firmware. Briefing asks for this only if it cannot restart the Go itself. |
Read the colour and the rhythm.
The skyBlip light only winks, to save the battery. A position means the satellite receiver has found where you are.
| Light | Meaning |
|---|---|
| Green, every 3 s | Running, with a position. |
| Blue, every 3 s | Running, no position yet. |
| Two winks every 3 s | A diagnostic recording started from Briefing is running. The colour still shows the position state. |
| Red, fast flicker | A traffic alarm is active. |
| Red, every 3 s | Battery low. |
| Red, every 600 ms | Battery critical. Land and charge. |
| One green pulse, 400 ms | Just switched on. On skyBlip Go+, you feel it too. |
| Three short red pulses | Switching off. On the Go+, you feel these too. |
| Dark | Off. |
The charger's separate red light stays lit while charging, blinks if the battery is missing or faulty, and goes out when full.
Choose your aircraft type
Choose an aircraft type and callsign during installation, or set them later. In Briefing, open your Go's page. On Go, press the button from the radar and open the AIRCRAFT menu. TYPE sets the aircraft type. CALLSIGN sets your callsign.
| Name in Briefing | Name on Go |
|---|---|
| Light aircraft | LIGHT |
| Heavy aircraft | HEAVY |
| Light helicopter | LIGHT HELI |
| Heavy helicopter | HEAVY HELI |
| Glider | GLIDER |
| Balloon | BALLOON |
| Microlight | MICROLIGHT |
| Paraglider | PARAGLIDER |
| Skydiver | SKYDIVER |
| VTOL | VTOL |
| Gyroplane | GYROCOPTER |
| Hang glider | HANG GLIDER |
| Paramotor | PARAMOTOR |
| Unknown | UNKNOWN |
Before you set off
Switch on Go in the open and wait for the skyBlip light to flash green. That means Go knows its position. Learn to read the radar, then connect your navigation app if you use one. Read the power guide for charging and storage.
After the flight
Hold the button for two seconds to switch Go off, then charge over USB-C. The logo stays on the screen. To store Go for weeks or a whole winter, rest a finger on the pad and hold the button for two seconds instead: Go switches off with a blank screen. An image left that long leaves a permanent shadow. See the charging and storage guide.
Want to try it now, or get one?