Guides

Bravo, one button and a light.

skyBlip Bravo warns you of approaching ADS-B traffic and sends it to your navigation app. Bravo only receives. It does not transmit your position.

In your hand

Press to answer, hold to switch off.

Bravo is a Seeed SenseCAP MeshTracker X1 running skyBlip. Its round button is on the top face. The USB-C port is on a short edge. There is no screen. The LED above the button, a buzzer and a vibration motor tell you what is happening.

Button LED USB-C
The X1 running skyBlip Bravo. Photo Seeed Studio.
GestureWhat it does
Press from offSwitches on, with one green pulse you feel.
Press during a fast red flickerSilences the alarm, including the paired Go while they are linked.
Press during a fast green blinkAllows a setting or update requested by a phone or Briefing. Without a press, it expires after 30 seconds.
Press during a fast blue blinkPairs with the Go that asked.
Hold for 2 sSwitches off, with three red pulses you feel.
Hold, plug in USB-C, keep holdingAfter about 3 seconds, the LED above the button turns white. The X1 becomes a USB drive named X1 for installing firmware by hand. Briefing asks only if it cannot restart Bravo itself.

A press begun before a request arrives answers nothing. A hold never answers a request. The browser that installed Bravo changes settings, updates it and pairs it without a press. Other browsers ask.

The colour gives the state, the rhythm gives the detail.

Blue means no satellite position yet. Green means Bravo knows where it is.

LightMeaning
One green pulse, feltJust switched on.
Blue, every 3 sNo position yet.
Green, every 3 sPosition found.
Either colour, every 1.5 sA phone or Briefing is connected.
Red, fast flickerTraffic alarm.
Green, fast blinkA request awaits your press.
Blue, fast blinkA Go asks to pair.
Two winks every 3 sA diagnostic recording is armed. The colour still shows the position state.
Red, every 3 sBattery low.
Red, every 600 msBattery critical. With a full battery, a traffic or satellite receiver is not answering and Bravo refuses to run.
Three red pulses, feltSwitching off, then dark.
DarkOff.
Steady whiteThe X1 is a USB drive for installing firmware.

Before you set off

Switch on Bravo in the open. When the light flashes green, Bravo knows its position. With Bravo on its own, connect your compatible navigation app over Bluetooth. With Tango, check on Go's radar that Bravo is connected. ADS-B traffic then appears on Go. It shows the positions that equipped aircraft transmit by radio.

If your own transponder shows up as another aircraft, check its address on the ground.

After the flight

Hold the button for two seconds to switch Bravo off. To update it, switch it back on and open its page in Briefing. Follow the instructions on screen.

Want to try it now, or get one?

Try it online the software in your browser
Get one a Go from €68, no subscription