[Guides](https://skyblip.eu/guides.md)

# Your Go, from the first press.

One press switches skyBlip Go on. Two seconds switches it off. Between the two, the pad moves through pages and silences alarms.

## In your hand

### Find the pad, then the button.

The pad is touch-sensitive, on the top edge. On the left side, the button is the lower of the two controls. RESET is above it. The USB-C port is on the right. Two lights sit beside the screen: skyBlip's red, green or blue light and the charger's red light.

The e-paper screen keeps its image without power. The logo means the Go is off.

| Gesture | What it does |
| --- | --- |
| Tap the pad | Opens the next page. On a request, refuses it: the screen's CANCEL key. |
| Touch the pad, 1 s | Silences an active alarm. With no alarm, returns to the radar. |
| Press the button | From off, starts the radar. On a page, opens its menu. In a menu, changes the selected value. On a request, accepts it. |
| Hold the button, 2 s | Switches off. The logo stays on the screen. |
| The same hold, finger on the pad | Switches off with a blank screen, for storage. An image left all winter leaves a shadow. |
| Hold the button and plug the charger in | Starts and charges. Plugging in alone charges and leaves it off. |
| Press RESET | Restarts the Go. |
| Press RESET twice within half a second | Opens TECHOBOOT, a USB drive for installing firmware. Briefing asks for this only if it cannot restart the Go itself. |

### Read the colour and the rhythm.

The skyBlip light only winks, to save the battery. A position means the satellite receiver has found where you are.

| Light | Meaning |
| --- | --- |
| Green, every 3 s | Running, with a position. |
| Blue, every 3 s | Running, no position yet. |
| Two winks every 3 s | A diagnostic recording started from Briefing is running. The colour still shows the position state. |
| Red, fast flicker | A traffic alarm is active. |
| Red, every 3 s | Battery low. |
| Red, every 600 ms | Battery critical. Land and charge. |
| One green pulse, 400 ms | Just switched on. On skyBlip Go+, you feel it too. |
| Three short red pulses | Switching off. On the Go+, you feel these too. |
| Dark | Off. |

The charger's separate red light stays lit while charging, blinks if the battery is missing or faulty, and goes out when full.

## Choose your aircraft type

Choose an aircraft type and callsign during installation, or set them later. In [Briefing](https://skyblip.eu/briefing), open your Go's page. On Go, press the button from the radar and open the `AIRCRAFT` menu. `TYPE` sets the aircraft type. `CALLSIGN` sets [your callsign](https://skyblip.eu/controls.md#callsign).

| Name in Briefing | Name on Go |
| --- | --- |
| Light aircraft | `LIGHT` |
| Heavy aircraft | `HEAVY` |
| Light helicopter | `LIGHT HELI` |
| Heavy helicopter | `HEAVY HELI` |
| Glider | `GLIDER` |
| Balloon | `BALLOON` |
| Microlight | `MICROLIGHT` |
| Paraglider | `PARAGLIDER` |
| Skydiver | `SKYDIVER` |
| VTOL | `VTOL` |
| Gyroplane | `GYROCOPTER` |
| Hang glider | `HANG GLIDER` |
| Paramotor | `PARAMOTOR` |
| Unknown | `UNKNOWN` |

## Before you set off

Switch on Go in the open and wait for the skyBlip light to flash green. That means Go knows its position. [Learn to read the radar](https://skyblip.eu/radar.md), then [connect your navigation app](https://skyblip.eu/phone.md) if you use one. Read the [power guide](https://skyblip.eu/power.md) for charging and storage.

## After the flight

Hold the button for two seconds to switch Go off, then charge over USB-C. The logo stays on the screen. To store Go for weeks or a whole winter, rest a finger on the pad and hold the button for two seconds instead: Go switches off with a blank screen. An image left that long leaves a permanent shadow. See [the charging and storage guide](https://skyblip.eu/power.md).

Want to try it now, or get one?

[Try it online](https://skyblip.eu/try.md) the software in your browser

[Get one](https://skyblip.eu/buy.md) a Go from €68, no subscription
