[Guides](https://skyblip.eu/guides.md)

# Bravo, one button and a light.

skyBlip Bravo warns you of approaching ADS-B traffic and sends it to your navigation app. Bravo only receives. It does not transmit your position.

## In your hand

### Press to answer, hold to switch off.

Bravo is a Seeed SenseCAP MeshTracker X1 running skyBlip. Its round button is on the top face. The USB-C port is on a short edge. There is no screen. The LED above the button, a buzzer and a vibration motor tell you what is happening.

_The X1 running skyBlip Bravo. Photo Seeed Studio._

| Gesture | What it does |
| --- | --- |
| Press from off | Switches on, with one green pulse you feel. |
| Press during a fast red flicker | Silences the alarm, including the paired Go while they are linked. |
| Press during a fast green blink | Allows a setting or update requested by a phone or Briefing. Without a press, it expires after 30 seconds. |
| Press during a fast blue blink | Pairs with the Go that asked. |
| Hold for 2 s | Switches off, with three red pulses you feel. |
| Hold, plug in USB-C, keep holding | After about 3 seconds, the LED above the button turns white. The X1 becomes a USB drive named X1 for installing firmware by hand. Briefing asks only if it cannot restart Bravo itself. |

A press begun before a request arrives answers nothing. A hold never answers a request. The browser that installed Bravo changes settings, updates it and pairs it without a press. Other browsers ask.

### The colour gives the state, the rhythm gives the detail.

Blue means no satellite position yet. Green means Bravo knows where it is.

| Light | Meaning |
| --- | --- |
| One green pulse, felt | Just switched on. |
| Blue, every 3 s | No position yet. |
| Green, every 3 s | Position found. |
| Either colour, every 1.5 s | A phone or Briefing is connected. |
| Red, fast flicker | Traffic alarm. |
| Green, fast blink | A request awaits your press. |
| Blue, fast blink | A Go asks to pair. |
| Two winks every 3 s | A diagnostic recording is armed. The colour still shows the position state. |
| Red, every 3 s | Battery low. |
| Red, every 600 ms | Battery critical. With a full battery, a traffic or satellite receiver is not answering and Bravo refuses to run. |
| Three red pulses, felt | Switching off, then dark. |
| Dark | Off. |
| Steady white | The X1 is a USB drive for installing firmware. |

## Before you set off

Switch on Bravo in the open. When the light flashes green, Bravo knows its position. With Bravo on its own, connect your compatible navigation app over Bluetooth. With Tango, check on Go's radar that Bravo is connected. ADS-B traffic then appears on Go. It shows the positions that equipped aircraft transmit by radio.

If your own transponder shows up as another aircraft, [check its address on the ground](https://skyblip.eu/install.md#si-quelque-chose-bloque).

## After the flight

Hold the button for two seconds to switch Bravo off. To update it, switch it back on and open its page in [Briefing](https://skyblip.eu/briefing). Follow the instructions on screen.

Want to try it now, or get one?

[Try it online](https://skyblip.eu/try.md) the software in your browser

[Get one](https://skyblip.eu/buy.md) a Go from €68, no subscription
